Crane-song HEDD 192 User Manual

©2000, 2009 Crane Song,LTD. Subject to change without notice. Printed in the U.S.A.CRANE SONG LTD.2117 East 5th StreetSuperior, WI 54

PROCESS BLOCK DIAGRAMSPAGE 710

PROCESS BLOCK DIAGRAMS (CONT.)PAGE 811

PAGE 9SPECIFICATIONSAnalog Output: Transformer-less balanced floating stereo output with XLR connectors.Digital zero is +16dBm. This allows 12 db of

Hedd upgradesThere are two parts to thisFirst, the D/A and the A/D converter; this requires some modification to the main pcb. How much depends on t

JUMPER ON = SRC ENABLEDTHIS IS THE LOW JITTER MODEJUMPER OFF = SRC DISABLEDTHIS IS THE LOW LATENCYMODEJUMPER ON = THE FILTER HAS A SLOW ROLL OFFJUMPER

-192 Harmonically Enhanced Digital DevicePlease fill out this form and return. It will be used for sending updatesand pertinent information as it be

INTRODUCTION ...PANEL REFERENCE ...CONTROL DESCRIPTION ...

IMPORTANT SAFETY INSTRUCTIONS1. Read these instructions2. Keep these instructions3. Heed all warnings4. Follow all instructions5. Do not use this appa

PAGE 2INTRODUCTIONHEDD, short for harmonically enha

PANEL REFERENCE PAGE 316 bit ditherno dither20 bit ditherprocress controlsSelect

PAGE 4THE CONTROLSSAMPLE RATE SWITCHThe A/D clock rate can be set from 44.1Khz to 192KHz or an external WC reference. The unitstaht were shipped going

PROCESS SWITCHThe process switch selects whether the signal processor is attached to the D/A convertor,A/D convertor, is configured for digital in - d

It is also possible to add this dither to an existing audio source. Dither can be added byrunning digital in, digital out and selecting the part of t

9HEDD AS A MASTER CLOCKHedd will make a very good master clock, however there are two modes where it will not work as amaster clock. This is with16 a